Subject	aem boost solinoid
Posted by	ZTom on December 22, 2015 at 9:07 AM
	This message has been viewed 236 times.
Message	I have a question for people that are using AEM boost control solenoid. This instructions said to hook up port 3 to boost pressure source and port 2 to waste gate actuator. Port 1 vent to the atmosphere. When energized port 2 is close and vent to port 1. It doesn't happen that way cause no air come out of port 1. But if you hook up port 2 to boost pressure source and port 3 to waste gate actuator, when it energized port 2 would close and air come out of port 1. Now I'm confuse. Any info on this will be greatly appreciated. I have eboost street boost controller.
Follow Ups	aem boost solinoid - ZTom 09:07:22 12/22/15
Post a Followup	You cannot reply to this message because you are not logged in.