Subject	Issue
Posted by	EngineerLV on December 21, 2015 at 8:39 PM
	This message has been viewed 435 times.
In Reply To	here is the issue posted by komplexZTT on December 21, 2015 at 05:36 PM
Message	Looks like your stop leaver is not seated all the way, if it seated all the way then the shaft is machined wrong and you should just send it back to rob. Grinding is not the answer, your stop leaver is off center of your threaded stop and could cause issues.
Follow Ups	RobZ 62mm TB not lining up, driver side - komplexZTT 11:45:09 12/20/15 Re: RobZ 62mm TB not lining up, driver side - sky z 14:47:25 12/21/15 here is the issue - komplexZTT 17:36:30 12/21/15 Issue - EngineerLV 20:39:02 12/21/15 Re: here is the issue - sky z 08:03:28 12/22/15 I removed the lock washer on linkage side - komplexZTT 19:52:13 12/22/15
Post a Followup	You cannot reply to this message because you are not logged in.