Subject	RobZ 62mm TB not lining up, driver side
Posted by	komplexZTT on December 20, 2015 at 11:45 AM
	This message has been viewed 556 times.
Message	Anyone have issue with the drivers side linkage not letting the TB sit in the right position/pushing out the TB too much? I've tightened down the nut as far as I will go (maybe even too much), even removed the lock washer, didn't buy too much. Any ideas on what to try? Based on the nut and shaft, I don't see much to play with. 2+2=4; 2+0=2; 4>2 : 2+2 > 2+0. SRC="http://img19.imageshack.us/img19/7674/kzttgina4.jpg"> Can anyone whos removed the headlights just by going through the turn signal hole, post a pic of their arms? Im just wondering if you have little tiny arms, or if you can somehow dislocate your wrists?...Im not saying im huge or anything, because im not - Ebola 23:10:42 01/20/05
Follow Ups	RobZ 62mm TB not lining up, driver side - komplexZTT 11:45:09 12/20/15 Re: RobZ 62mm TB not lining up, driver side - sky z 14:47:25 12/21/15 here is the issue - komplexZTT 17:36:30 12/21/15 Issue - EngineerLV 20:39:02 12/21/15 Re: here is the issue - sky z 08:03:28 12/22/15 I removed the lock washer on linkage side - komplexZTT 19:52:13 12/22/15
Post a Followup	You cannot reply to this message because you are not logged in.