Subject	Re: CAS is not in the center to set my timing at 15
Posted by	MaxxAction on October 25, 2015 at 7:02 PM
	This message has been viewed 246 times.
In Reply To	CAS is not in the center to set my timing at 15 posted by JFRacing on October 25, 2015 at 06:00 PM
Message	The JWT cams will make it very slightly, but it should be within a few degrees of the center. How much was the block decked.
Follow Ups	CAS is not in the center to set my timing at 15 - JFRacing 18:00:37 10/25/15 Re: CAS is not in the center to set my timing at 15 - MaxxAction 19:02:05 10/25/15 Re: Re: CAS is not in the center to set my timing at 15 - JFRacing 19:13:43 10/25/15 Re: Re: Re: CAS is not in the center to set my timing at 15 - MaxxAction 19:39:31 10/25/15 Re: Re: Re: Re: CAS is not in the center to set my timing at 15 - JFRacing 20:38:21 10/25/15 Do you have +0.010" head gaskets? (n/m) - -Grimm- 10:26:49 10/26/15 Re: Do you have +0.010" head gaskets? - JFRacing 11:03:23 10/26/15 Your timing will be off by... - -Grimm- 15:07:17 10/26/15 Out of curiosity, how do you get those #? - ttsmokin 10:14:59 10/27/15 Do you have conzult or similar program? - ttsmokin 21:55:30 10/25/15 Re: Do you have conzult or similar program? - JFRacing 11:03:57 10/26/15 Inspect CAS splines and flat for wear (n/m) - ttsmokin 13:21:12 10/26/15 Re: CAS is not in the center to set my timing at 15 - Coolspot 09:17:24 10/27/15 Flip the connector over and you'll get the right reading. (n/m) - Woody75 (Denver) 09:25:11 10/27/15 Re: Re: CAS is not in the center to set my timing at 15 - JFRacing 11:35:03 10/27/15
Post a Followup	You cannot reply to this message because you are not logged in.