Subject	I don't understand
Posted by	wickdGSXR on September 21, 2015 at 5:57 PM
	This message has been viewed 362 times.
In Reply To	96tt breather mod and E85 question posted by Lone Z'er(CO) on September 20, 2015 at 01:29 PM
Message	I personally don't like pulling the motor out more times than I have to. Did you do a compression test first? if your rings/valves are bad then any mods are pointless. Assuming your bearings/rings/valves are good, then you want to do whatever mods must be done while the engine is out. Installing a Walbro, going e85 lines, etc can be done later. I went 740cc injectors then changed my mind. Not sure they can supply enough e85 for a fully built Z. Replacing parts and dynotuning over and over again cost $$$.
Follow Ups	96tt breather mod and E85 question - Lone Z'er(CO) 13:29:55 09/20/15 I don't understand - wickdGSXR 17:57:58 09/21/15 My engine is already out. I need to get my heads done. I had - Lone Z'er(CO) 13:41:25 09/22/15
Post a Followup	You cannot reply to this message because you are not logged in.