TwinTurbo.NET: Nissan 300ZX forum - Looks like you bent the fork, that looks like a stock fork?
Subject
Looks like you bent the fork, that looks like a stock fork?
Posted by
Tanley
on August 04, 2015 at 7:23 PM
This message has been viewed
271
times.
In Reply To
Clutch problem 2 weeks before SZ dyno tune..
posted by Stanky
on August 04, 2015 at 05:33 PM
Message
If your profile is correct and you're running an SZ High 5 then you should upgrade to the heavy duty fork. Pretty common for them to bend/break with the stronger pressure plates.
Follow Ups
Clutch problem 2 weeks before SZ dyno tune..
-
Stanky
17:33:35 08/04/15
Pull the slave and trans fork boot, inspect with a light
-
ttsmokin
17:58:22 08/04/15
just did, something doesn't look right. Video inside
-
Stanky
18:34:14 08/04/15
Looks bent to me
-
ttsmokin
21:25:56 08/04/15
Almost looks like the pivot seat is wallered out and is
-
Zuberman
00:48:40 08/05/15
I will pull tranny tomorrow and report back
-
Stanky
04:04:38 08/05/15
Looks like you bent the fork, that looks like a stock fork? -
Tanley
19:23:19 08/04/15
also, don't forget bleed line at front drivers side byHICAS (n/m)
-
wickdGSXR
21:25:48 08/04/15
Post a
Followup
You cannot reply to this message because you are not
logged in
.