Subject	Lower injector insulator question...searched
Posted by	monkeymantn on August 02, 2015 at 8:51 AM
	This message has been viewed 249 times.
Message	I am replacing the injectors on my 93 2+2. I am reading the FAQ on the plenum pull/injector replacement. On the section for replacing the lower insulators, he states that there is a bevel on each insulator but he cannot remember which way it should be installed. To me, all of the sides look the same and I cannot see a bevel on the new insulators; I do see a line (ring) on one end that will either be up or down depending on how I install them. As I pulled my old insulators out, four of them had this line up and two had it down. One of the two was from a bad cylinder and it looked totally destroyed. I can't remember how to post pictures, or else I would. Does anybody have any suggestions as to which way they should be installed? Thanks for any help my Z brethern.
Follow Ups	Lower injector insulator question...searched - monkeymantn 08:51:08 08/02/15 Re: Lower injector insulator question...searched - ttz'in (norcal) 09:06:58 08/02/15 See if this helps.... - Zuberman 13:29:59 08/02/15 Re: See if this helps.... - monkeymantn 16:28:30 08/02/15 I don't see any bevels on mine (based on old pics) (n/m) - OverZealous (CT) 16:53:15 08/03/15 So it's not the same insulator as discussed in the third - Zuberman 05:19:20 08/04/15 Just changed my injectors along with the insulators, didn't - YlwPrlZTT 18:45:56 08/06/15
Post a Followup	You cannot reply to this message because you are not logged in.