Subject	okay, i have a question about my tensioner too
Posted by	Z32CheekiBreeki on July 23, 2015 at 3:59 PM
	This message has been viewed 215 times.
In Reply To	Use a tiny flat heat, hammer it in the face lightly posted by -Grimm- on July 23, 2015 at 02:46 PM
Message	I broke the tab on a newer one I was gonna reuse from my NA for my turbo motor, can I just swap over the components from the 'new' one onto the base of the old one?
Follow Ups	Valves hit piston during timing belt change - Z32CheekiBreeki 10:44:18 07/23/15 Was it the passenger side? - Woody75 (Denver) 12:41:28 07/23/15 yes it was - Z32CheekiBreeki 12:44:25 07/23/15 Yes, this is common. - Woody75 (Denver) 13:00:00 07/23/15 Re: Valves hit piston during timing belt change - MaxxAction 12:48:44 07/23/15 Okay thanks for the replies - Z32CheekiBreeki 13:06:37 07/23/15 Use a tiny flat heat, hammer it in the face lightly - -Grimm- 14:46:01 07/23/15 okay, i have a question about my tensioner too - Z32CheekiBreeki 15:59:43 07/23/15 yes. (n/m) - Woody75 (Denver) 16:21:25 07/23/15 If you rotate the crank slightly clockwise of TDC all of the - xpwarrior 16:56:10 07/23/15
Post a Followup	You cannot reply to this message because you are not logged in.