Subject	drill a small hole in the center of the broken stud >>>
Posted by	ZUL8TR on July 22, 2015 at 2:17 PM
	This message has been viewed 263 times.
In Reply To	My mistake; 15 degrees. I haven't tested injectors yet.. posted by Mikester(Seattle) on July 22, 2015 at 01:13 PM
Message	not easy if broken at an angle or if bolt is a hardened piece. Center punch first to get the drill started. drill it about 3/8" in then drill it bogger to match the Easy Out and screw it in with a wrench (they screw in CCW to aid in removal). Some penetrating spray like PB Blaster or my favorite Kroil Oil. ZUL8TR in Orlando,FL
Follow Ups	Lacking power in my 91 NA. What's next to check? - Mikester(Seattle) 00:26:10 07/22/15 Timing 10 ? should be 15 +/- 2. What do the injectors ohm?>> - ZUL8TR 03:54:45 07/22/15 My mistake; 15 degrees. I haven't tested injectors yet.. - Mikester(Seattle) 13:13:03 07/22/15 drill a small hole in the center of the broken stud >>> - ZUL8TR 14:17:11 07/22/15 1-4 were 14.5, 15.5, 24, 15 ohms. Haven't tested 5-6 but.. - Mikester(Seattle) 00:21:52 07/23/15 Hot or cold the range is 10 to 14 ohms. You are above that - ZUL8TR 04:40:31 07/23/15 Replace those injectors. You've found a problem so tackle - flashstar 12:23:01 07/23/15 Thanks guys! I'm on it. :) (n/m) - Mikester(Seattle) 15:35:30 07/23/15
Post a Followup	You cannot reply to this message because you are not logged in.