Subject	Awesome, mystery solved. Any luck with support from Fidanza?
Posted by	HillZTT on July 22, 2015 at 6:26 AM
	This message has been viewed 296 times.
In Reply To	I was able to inspect the flywheel.... posted by SkiFly01 on July 21, 2015 at 06:22 PM
Message	Sucks you have to drop the trans, but at least you can stop spending money and time on starters... ------------------ Tada! "Low compression in cylinder 6." SRC="http://img54.imageshack.us/img54/783/disassembly123fz6.jp g">
Follow Ups	starter doesn't engage when cold - SkiFly01 14:24:46 07/18/15 Turn the crank with a wrench a bit, you may have - njz 21:13:29 07/18/15 No broken teeth, I looked when the starter was off - SkiFly01 02:55:10 07/19/15 check to make sure you have the washer as a shim (n/m) - diamond20601 11:15:36 07/19/15 The only washer I see in the FSM is for the + cable - SkiFly01 01:26:23 07/20/15 Check if Fidanza ring gear is spinning around the flywheel - HillZTT 07:48:43 07/20/15 ^^ That may explain "when cold".. (n/m) - njz 09:39:54 07/20/15 Fidanza ring gear watch youtube link - njz 09:46:47 07/20/15 I'll have to check into this, best explanation I've seen. - SkiFly01 10:37:53 07/20/15 Yup. Checked your profile to see if you did before posting - HillZTT 12:22:39 07/20/15 One of the video replies was from Fidanza Performance... - SkiFly01 14:37:56 07/20/15 I was able to inspect the flywheel.... - SkiFly01 18:22:22 07/21/15 Awesome, mystery solved. Any luck with support from Fidanza? - HillZTT 06:26:11 07/22/15 Called Fidanza, Awesome support btw. - SkiFly01 15:17:46 07/22/15 Good to know. Did they mention any design change? - HillZTT 08:55:27 07/23/15 The Fidanza Tech claimed it to be.... - SkiFly01 20:06:26 07/23/15
Post a Followup	You cannot reply to this message because you are not logged in.