Subject	Mine took a 13mm square bit. It was too hard
Posted by	not4resaleZ on July 20, 2015 at 6:25 PM
	This message has been viewed 328 times.
In Reply To	pipe wrench won't work these are 13mm hex bit (n/m) posted by WE350Z on July 20, 2015 at 02:53 PM
Message	to turn and rounded out. The plug protruded out a little, enough to get a pipe wrench around the whole plug. This is what I tried to use: [ http://ultimatetoolco.com/13mm ]
Follow Ups	Trans Fill Plug Stuck - WE350Z 03:00:15 07/20/15 Re: Trans Fill Plug Stuck - MaxxAction 07:42:52 07/20/15 Yeah I would also suggest not using a torque wrench - -Grimm- 09:39:50 07/20/15 Also - -Grimm- 09:41:29 07/20/15 I had a problem with the differential plug on my Infiniti. - not4resaleZ 11:59:03 07/20/15 pipe wrench won't work these are 13mm hex bit (n/m) - WE350Z 14:53:09 07/20/15 Mine took a 13mm square bit. It was too hard - not4resaleZ 18:25:06 07/20/15 Dang - $30 bones for a socket! >> - WE350Z 18:50:15 07/20/15 That won't work. Need Square. I think I rounded mine - not4resaleZ 11:44:14 07/21/15 So I need to buy the $30 socket or risk rounding it with the - WE350Z 12:23:30 07/21/15 You can try the 1/2" but you do risk rounding it out. - not4resaleZ 13:06:54 07/21/15 Thanks was wondering where to apply the heat, as for the >> - WE350Z 17:37:07 07/21/15 If it's beat up, get a new plug. I'd just torque to spec. (n/m) - not4resaleZ 17:30:43 07/22/15 got it - i think mine is OK but I'll see how it looks after> - WE350Z 14:36:10 07/24/15 I had no idea there was a socket for that - ZXRider 13:27:02 07/23/15 yeah - 1/2" drive works out to 12.6mm which is not correct > - WE350Z 14:35:27 07/24/15 Thanks for the input guys >> - WE350Z 14:18:01 07/20/15 I've had to use a floor jack handle with my breaker bar once - Polish 00:02:37 07/21/15 Left loosy! (n/m) - WE350Z 12:19:34 07/21/15 I'm hoping i can get my breaker bar on enough of an angle > - WE350Z 14:42:44 07/24/15
Post a Followup	You cannot reply to this message because you are not logged in.