Subject	Bellhousing is just that
Posted by	-Grimm- on July 16, 2015 at 1:33 PM
	This message has been viewed 420 times.
In Reply To	Why not call it a bellhousing? posted by TriniTT on July 16, 2015 at 01:22 PM
Message	the section that surrounds the flywheel/flexplate between the engine and transmission. The fact that out bellhousing and transmission body are one piece changes everything, you have to disassemble the trans to remove it. Maybe I'm just nitpicky. ------------------------------------------------------------------ 1992 300ZX NA 5 Sp (Dead) 1990 300ZX NA Auto 2+2 (Dead) 1990 300ZX TT 5 Sp (Est. 400 HP) 1990 300ZX TT 5 Sp (Est. 600 HP) 2004 G35 Sport 6MT (DD) 2008 Honda Civic (DD) 1969 Chevy C10 (Toy) 1969 Chevelle (Toy)
Follow Ups	I want to buy a tt tranny for my 300zx n/a would it fit? - josen/a300zx 18:53:05 07/13/15 sounds like the input shaft bearing - -Grimm- 09:42:42 07/15/15 swap over the bell housings (n/m) - itsa300zx 11:51:57 07/15/15 Not possible on our cars (n/m) - -Grimm- 13:51:44 07/15/15 are you sure about that - itsa300zx 14:14:44 07/15/15 Yes it can be done, but this may exceed the value - ttz'in (norcal) 14:48:37 07/15/15 I wouldnt call that a bell housing... (n/m) - -Grimm- 15:50:21 07/15/15 what is the technical name for it? so I know for future (n/m) - itsa300zx 15:55:35 07/15/15 case assy-transmission (n/m) - ttz'in (norcal) 17:57:49 07/15/15 Yeah something like that - -Grimm- 17:59:29 07/15/15 Why not call it a bellhousing? - TriniTT 13:22:13 07/16/15 Bellhousing is just that - -Grimm- 13:33:01 07/16/15 Ask Nissan.. - ttz'in (norcal) 14:56:39 07/16/15 dont think a TT tranny should have an issue bolting to an NA - Z32CheekiBreeki 23:27:12 07/15/15 Re: dont think a TT tranny should have an issue bolting to an NA - MaxxAction 08:07:14 07/16/15
Post a Followup	You cannot reply to this message because you are not logged in.