Subject	dont think a TT tranny should have an issue bolting to an NA
Posted by	Z32CheekiBreeki on July 15, 2015 at 11:27 PM
	This message has been viewed 364 times.
In Reply To	I want to buy a tt tranny for my 300zx n/a would it fit? posted by josen/a300zx on July 13, 2015 at 06:53 PM
Message	the flywheel/clutch assembly has a smaller diameter on the NA than the TT and the bolt pattern is the same so it should clear fine I could see some issues with the starter though
Follow Ups	I want to buy a tt tranny for my 300zx n/a would it fit? - josen/a300zx 18:53:05 07/13/15 sounds like the input shaft bearing - -Grimm- 09:42:42 07/15/15 swap over the bell housings (n/m) - itsa300zx 11:51:57 07/15/15 Not possible on our cars (n/m) - -Grimm- 13:51:44 07/15/15 are you sure about that - itsa300zx 14:14:44 07/15/15 Yes it can be done, but this may exceed the value - ttz'in (norcal) 14:48:37 07/15/15 I wouldnt call that a bell housing... (n/m) - -Grimm- 15:50:21 07/15/15 what is the technical name for it? so I know for future (n/m) - itsa300zx 15:55:35 07/15/15 case assy-transmission (n/m) - ttz'in (norcal) 17:57:49 07/15/15 Yeah something like that - -Grimm- 17:59:29 07/15/15 Why not call it a bellhousing? - TriniTT 13:22:13 07/16/15 Bellhousing is just that - -Grimm- 13:33:01 07/16/15 Ask Nissan.. - ttz'in (norcal) 14:56:39 07/16/15 dont think a TT tranny should have an issue bolting to an NA - Z32CheekiBreeki 23:27:12 07/15/15 Re: dont think a TT tranny should have an issue bolting to an NA - MaxxAction 08:07:14 07/16/15
Post a Followup	You cannot reply to this message because you are not logged in.