Subject	What I need is a 16" long 1/8th inch drill bit.
Posted by	Zbullet on July 02, 2015 at 9:23 PM
	This message has been viewed 535 times.
In Reply To	=> BRB <= posted by OverZealous (CT) on July 02, 2015 at 09:11 PM
Message	Yeah - to get that bolt drilled out and the hole re-tapped I'd have to drop the oil pan. The leak wasn't that bad. Just enough to coat the bell housing with a thick layer of grime. I'm just a little nervous I might make it worse if I pull the seals and retainer for the fresh parts. I didn't do the rebuild, so the bolt was likely broken by the previous owner upon installation of the pan. :-(
Follow Ups	Broken Oil Pan bolt, slight leak at the RMS - Zbullet 20:41:46 07/02/15 => BRB <= - OverZealous (CT) 21:11:39 07/02/15 What I need is a 16" long 1/8th inch drill bit. - Zbullet 21:23:29 07/02/15 Re: What I need is a 16" long 1/8th inch drill bit. - OverZealous (CT) 22:26:31 07/02/15 Been there with that exact bolt broken - ThisIsSparTTa 08:54:48 07/08/15 CRAP! Thanks for the input. - Zbullet 22:33:31 07/09/15
Post a Followup	You cannot reply to this message because you are not logged in.