Subject	No suggestions, but make sure you have clearance.
Posted by	Zbullet on July 02, 2015 at 8:21 PM
	This message has been viewed 484 times.
In Reply To	Anyone have a trick to perfectly align the Zspeed shifter posted by Tanley on July 01, 2015 at 08:41 PM
Message	I had what I thought was some grinding after a tranny swap and realized when I pulled the transmission that the shifter was rubbing my CF driveshaft. Joe said to bend the bracket in advice for some extra clearance. I opted to go back to the OEM bracket instead.
Follow Ups	Anyone have a trick to perfectly align the Zspeed shifter - Tanley 20:41:00 07/01/15 2nd! I can't get mine set perfectly either (n/m) - flashstar 01:32:46 07/02/15 No suggestions, but make sure you have clearance. - Zbullet 20:21:16 07/02/15 I'll take a look, something is just not right with mine. - Tanley 08:44:20 07/03/15 2nd. It's hard to get into 1st and 5th on mine. The - flashstar 01:13:42 07/04/15 Your shifter bushings are probably too tight - Polish 17:25:35 07/05/15 I'm using a new-style Z1 shifter - flashstar 23:13:12 07/05/15 probably an interference problem between the shifter - aliaZ 22:03:21 07/07/15
Post a Followup	You cannot reply to this message because you are not logged in.