Subject	Readjust the throttole control per spec >>>>>
Posted by	ZUL8TR on July 02, 2015 at 2:42 AM
	This message has been viewed 574 times.
In Reply To	High idle, not erratic idle >>> posted by stockplayerz(nyc) on July 01, 2015 at 08:40 PM
Message	here is the TPS adjust procedure [ http://z32.wikispaces.com/Throttle+Position+Sensor ] Even with the TPS set correctly idle will suddenly increase and hold also the IAA and AAC could also need service. [ http://300zx-twinturbo.com/cgi-bin/manual.cgi?list=efec&dir=&config=&refresh=&direction=forward&scale=0&cycle=off&slide=17&design=default&total=190 ] What I do to correct the idle is shut off engine then turn on key to start position with (do not start). Unplug the TPS for about 5 sec then replug. Turn off key then start engine and idle is back to normal until the next time it goes high. Note after TPS adjustment do this procedure to reset the system. ZUL8TR in Orlando,FL
Follow Ups	High idle, not erratic idle >>> - stockplayerz(nyc) 20:40:22 07/01/15 Yes, the coolant temp sensor affects idle. (n/m) - Tanley 20:43:26 07/01/15 As might the wires leading to PTU.. (n/m) - ttz'in (norcal) 00:38:23 07/02/15 Readjust the throttole control per spec >>>>> - ZUL8TR 02:42:36 07/02/15 anytime I had a high idle, it was a slight vacuum leak (n/m) - wickdGSXR 09:53:02 07/02/15 thank you to all of you- very much appreciated! (n/m) - stockplayerz(nyc) 21:00:32 07/02/15 Well what was the fix?! (n/m) - FrozTTy 20:32:05 07/06/15
Post a Followup	You cannot reply to this message because you are not logged in.