Subject	They poped in by hand easily, it seems like they're all the
Posted by	YlwPrlZTT on June 29, 2015 at 7:08 PM
	This message has been viewed 261 times.
In Reply To	difficult, but they should pop in using thumbs posted by wickdGSXR on June 29, 2015 at 06:50 PM
Message	way seated, it's just there is a very small gap between the plastic and the fuel rail. I tightened the screws a little more and there is no gap between the screw and the fuel rail but the injector didn't more. I'm guessing it's all the way seated but the fit is just not 100% on top.
Follow Ups	Is this going to be a problem? - YlwPrlZTT 15:39:46 06/29/15 difficult, but they should pop in using thumbs - wickdGSXR 18:50:48 06/29/15 They poped in by hand easily, it seems like they're all the - YlwPrlZTT 19:08:28 06/29/15 Re: Is this going to be a problem? - sky z 19:17:50 06/29/15 Ok, installed it, leak tested, all good to go. The Z is - YlwPrlZTT 01:11:02 06/30/15 Good Job.. (n/m) - ttz'in (norcal) 11:32:36 06/30/15
Post a Followup	You cannot reply to this message because you are not logged in.