Subject	Is this going to be a problem?
Posted by	YlwPrlZTT on June 29, 2015 at 3:39 PM
	This message has been viewed 399 times.
Message	I just got these injectors from Concept Z, I installed all the O-rings seated the injectors by hand they they don't mate all the way. It is is the same for all the injectors so I doubt it's the o-ring. I can tighten the screws a little more I just don't want to damage the plastic. Has anyone seen this before?
Follow Ups	Is this going to be a problem? - YlwPrlZTT 15:39:46 06/29/15 difficult, but they should pop in using thumbs - wickdGSXR 18:50:48 06/29/15 They poped in by hand easily, it seems like they're all the - YlwPrlZTT 19:08:28 06/29/15 Re: Is this going to be a problem? - sky z 19:17:50 06/29/15 Ok, installed it, leak tested, all good to go. The Z is - YlwPrlZTT 01:11:02 06/30/15 Good Job.. (n/m) - ttz'in (norcal) 11:32:36 06/30/15
Post a Followup	You cannot reply to this message because you are not logged in.