Subject	Re: Re: Check out these bores...what ya think?
Posted by	Matt300ZXT on June 19, 2015 at 1:34 PM
	This message has been viewed 219 times.
In Reply To	Re: Check out these bores...what ya think? posted by MaxxAction on June 19, 2015 at 01:32 PM
Message	Didn't notice any rings falling apart when I took the pistons out, though I can go check the corresponding piston here in a bit when I get back downstairs to the garage. Being up so high I didn't know if it'd effect the sealing of the bore or if it'd create some way bad hot spot and cylinder temps would run real high in that bore or whatever.
Follow Ups	Check out these bores...what ya think? - Matt300ZXT 13:19:02 06/19/15 Re: Check out these bores...what ya think? - MaxxAction 13:32:19 06/19/15 Re: Re: Check out these bores...what ya think? - Matt300ZXT 13:34:42 06/19/15 ^ Agree ^ W/ MaxxAction post. (n/m) - ttz'in (norcal) 15:50:36 06/19/15 Re: ^ Agree ^ W/ MaxxAction post. - Matt300ZXT 17:20:27 06/19/15 I'd look at the Piston on 4 - Cjw3 19:24:12 06/19/15 Re: I'd look at the Piston on 4 - Matt300ZXT 09:41:38 06/20/15 Re: Re: I'd look at the Piston on 4 - Cjw3 11:19:21 06/20/15 Re: Check out these bores...what ya think? - Tech@EPR 22:52:02 06/21/15
Post a Followup	You cannot reply to this message because you are not logged in.