Subject	Re: Check out these bores...what ya think?
Posted by	MaxxAction on June 19, 2015 at 1:32 PM
	This message has been viewed 304 times.
In Reply To	Check out these bores...what ya think? posted by Matt300ZXT on June 19, 2015 at 01:19 PM
Message	Did it have a broken ring?? That one scratch looks pretty gnarly man. It almost looks like the ring was not filed correctly on that cylinder, but it does appear to be up past where the rings will seal. I think it would probably work fine after running a hone down it a couple times to break the glaze.
Follow Ups	Check out these bores...what ya think? - Matt300ZXT 13:19:02 06/19/15 Re: Check out these bores...what ya think? - MaxxAction 13:32:19 06/19/15 Re: Re: Check out these bores...what ya think? - Matt300ZXT 13:34:42 06/19/15 ^ Agree ^ W/ MaxxAction post. (n/m) - ttz'in (norcal) 15:50:36 06/19/15 Re: ^ Agree ^ W/ MaxxAction post. - Matt300ZXT 17:20:27 06/19/15 I'd look at the Piston on 4 - Cjw3 19:24:12 06/19/15 Re: I'd look at the Piston on 4 - Matt300ZXT 09:41:38 06/20/15 Re: Re: I'd look at the Piston on 4 - Cjw3 11:19:21 06/20/15 Re: Check out these bores...what ya think? - Tech@EPR 22:52:02 06/21/15
Post a Followup	You cannot reply to this message because you are not logged in.