Subject	Check out these bores...what ya think?
Posted by	Matt300ZXT on June 19, 2015 at 1:19 PM
	This message has been viewed 453 times.
Message	I bought this bottom end mostly for the pistons/rods/crank/hardware. If the block wasn't 100% usable it isn't the biggest loss in the world but would love to use it if I can since it's already bored, line honed since ARP hardware was in it, galleys fitted with threaded plugs, etc so I'm going to post some pics. To my untrained eyes, they look ok, except cylinder 4 has the scratch in the pic, you'll know it when you see it. It may not show it in the 2nd pic but there is another much fainter scratch that barely catches my nail about 1/4 way around the same bore. The other cylinders look good to me, still plenty of crosshatching evident. Anyways, here's the way the pics will go. There are 2 pics per cylinder, 1 from each side going in order of 1,2,3, and so on. Chime in with your opinions. And here is a close up of the scratch in #4
Follow Ups	Check out these bores...what ya think? - Matt300ZXT 13:19:02 06/19/15 Re: Check out these bores...what ya think? - MaxxAction 13:32:19 06/19/15 Re: Re: Check out these bores...what ya think? - Matt300ZXT 13:34:42 06/19/15 ^ Agree ^ W/ MaxxAction post. (n/m) - ttz'in (norcal) 15:50:36 06/19/15 Re: ^ Agree ^ W/ MaxxAction post. - Matt300ZXT 17:20:27 06/19/15 I'd look at the Piston on 4 - Cjw3 19:24:12 06/19/15 Re: I'd look at the Piston on 4 - Matt300ZXT 09:41:38 06/20/15 Re: Re: I'd look at the Piston on 4 - Cjw3 11:19:21 06/20/15 Re: Check out these bores...what ya think? - Tech@EPR 22:52:02 06/21/15
Post a Followup	You cannot reply to this message because you are not logged in.