Subject	It should be stamped as an abbreviation somewhere on the
Posted by	Zuberman on June 18, 2015 at 1:38 AM
	This message has been viewed 193 times.
In Reply To	Head Light Housing Material? posted by ZXRider on June 17, 2015 at 03:46 PM
Message	backside of the housing. https://www.youtube.com/watch?v=Q5wYxfEZVJc I recently repaired the tab on the tail-light housing on my van, and I didn't even use the screen as described in that video and it has held up fine. It genuinely suprised me how hard and tough it turned out. That Urethane Supply Company airless plastic welder in that video is the same one I have, and I have found it works great. Just match up the supplied plastic rod with the abbreviation :)
Follow Ups	Head Light Housing Material? - ZXRider 15:46:47 06/17/15 It should be stamped as an abbreviation somewhere on the - Zuberman 01:38:27 06/18/15 Ya normally they would have the material, cavity number - ZXRider 11:42:23 06/18/15
Post a Followup	You cannot reply to this message because you are not logged in.