Subject	I pull it together
Posted by	-Grimm- on June 16, 2015 at 12:11 PM
	This message has been viewed 194 times.
In Reply To	No. Many posts frown on pulling them connected. It posted by ZTicket(Dallas) on June 16, 2015 at 06:34 AM
Message	Much easier to remove the trans out of the car than underneath... I do, however, unbolt the tension rods and four subframe studs to lower the subframe an inch or two to help clear the oil pan/PS rack ------------------------------------------------------------------ 1992 300ZX NA 5 Sp (Dead) 1990 300ZX NA Auto 2+2 (Dead) 1990 300ZX TT 5 Sp (Est. 400 HP) 1990 300ZX TT 5 Sp (Est. 600 HP) 2004 G35 Sport 6MT (DD) 2008 Honda Civic (DD) 1969 Chevy C10 (Toy) 1969 Chevelle (Toy)
Follow Ups	What to do while the engine is out/general questions - Z32CheekiBreeki 19:18:12 06/15/15 EFI Harness ? Steering Rack Service / Bushings ? - ttz'in (norcal) 19:36:41 06/15/15 High pressure power steering hose is one adder. How about - jzack 19:46:14 06/15/15 BDE half moons seals, blackholes solenoid caps. I did the - itsa300zx 19:51:15 06/15/15 Cant believe I forgot about the PS pump hose - Z32CheekiBreeki 19:54:51 06/15/15 I highly recommend a new harness if it's still the original. - itsa300zx 21:06:46 06/16/15 Re: What to do while the engine is out/general questions - cremion 21:37:18 06/15/15 Detonation sensor and harness. - Goldchocobo 22:07:30 06/15/15 Added to the list - Z32CheekiBreeki 06:14:00 06/16/15 No. Many posts frown on pulling them connected. It - ZTicket(Dallas) 06:34:10 06/16/15 I pull it together - -Grimm- 12:11:02 06/16/15 Having enough room in the garage in front of the Z is one - jzack 17:53:53 06/16/15
Post a Followup	You cannot reply to this message because you are not logged in.