Subject	Re: Lets discuss..
Posted by	Svt_troy on June 14, 2015 at 10:18 PM
	This message has been viewed 198 times.
In Reply To	Lets discuss.. posted by Cjw3 on June 14, 2015 at 10:45 AM
Message	I understand what you are saying. AEM list their sensors accuracy. The SS sensor is +/- .5 and their copper sensor is +/- 3 psi both including repeatability I figured out that Haltechs sensor is a TI sensor with the same +/- .5 accuracy. So at this point I'm thinking I could use whatever i find as long as it has the same rating. Of course considering the repeatability. I also need to figure out if Haltech's program allows for or will require a formula change if I do get a different sensor.
Follow Ups	Question about pressure sensors - Svt_troy 08:50:30 06/14/15 The trick is getting it all hooked up properly - Cjw3 09:44:59 06/14/15 Re: The trick is getting it all hooked up properly - Svt_troy 09:55:42 06/14/15 Lets discuss.. - Cjw3 10:45:40 06/14/15 Re: Lets discuss.. - Svt_troy 22:18:29 06/14/15
Post a Followup	You cannot reply to this message because you are not logged in.