Subject	You need to close the Wires together to get Idle Mode..
Posted by	Cjw3 on June 08, 2015 at 8:13 PM
	This message has been viewed 255 times.
In Reply To	Another question posted by Goldchocobo on June 08, 2015 at 07:43 PM
Message	As I mentioned on the other post.. I had an ECU that could not see the idle switch.. the replacement ECU could.. so it was a defective ECU.. I only found that with ECU Talk.. or Conzult will see it also.. They use the same interface.. Cj
Follow Ups	Ignition timing issues - Goldchocobo 16:11:13 06/08/15 15 Is only at Idle.. - Cjw3 18:53:44 06/08/15 Re: 15 Is only at Idle.. - Goldchocobo 19:27:55 06/08/15 It's the Green/Red.. Lt Green/Red wire set - Cjw3 19:47:35 06/08/15 Another question - Goldchocobo 19:43:00 06/08/15 You need to close the Wires together to get Idle Mode.. - Cjw3 20:13:57 06/08/15 UPDATE - Goldchocobo 21:11:53 06/08/15 Yeah, don't use that loop...use the #1 coil wire. (n/m) - ChristopherTheOne 22:37:01 06/08/15 Take the timing off the first coil always, the loop's timing - puchy 22:37:27 06/08/15 I was testing both just to be thorough. - Goldchocobo 23:25:18 06/08/15
Post a Followup	You cannot reply to this message because you are not logged in.