Subject	The machine shop installed the rings/pistons for me ->
Posted by	james92se on June 07, 2015 at 5:43 PM
	This message has been viewed 213 times.
In Reply To	Just coat with non synthetic engine oil that will be used >> posted by ZUL8TR on June 07, 2015 at 04:18 AM
Message	So no I did not do anything with hot water and soap etc. I do see/feel a little bit of oily stuff under the pistons, so I know they didn't do it completely dry. I was hoping to get my oil pan on this weekend, but the main stud kit I bought from Z1 and attempted to install yesterday very annoyingly had one incorrect (too small) stud, which totally brought me to a halt. So now I have to wait for them to send me a replacement, which I hope they will do ASAP and I can do it next weekend. As soon as I get that and can install the main studs I'll get the oil pan on.
Follow Ups	Fresh overbore + Wiseco pistons, how to store block? - james92se 13:56:33 06/06/15 I have not done it personally,but I've see a block come out - itsa300zx 14:24:09 06/06/15 My heads were off my short block for a few months - flashstar 16:20:44 06/06/15 Just coat with non synthetic engine oil that will be used >> - ZUL8TR 04:18:08 06/07/15 Re: Just coat with non synthetic engine oil that will be used >> - sky z 08:13:09 06/07/15 The machine shop installed the rings/pistons for me -> - james92se 17:43:50 06/07/15 Ask them how they cleaned the cylinders after the >> - ZUL8TR 02:29:05 06/08/15 Re: Fresh overbore + Wiseco pistons, how to store block? - MaxxAction 09:04:11 06/07/15 I never said it was hard? Just wanted a specific example (n/m) - james92se 17:45:30 06/07/15 ATF (n/m) - -Grimm- 10:18:25 06/08/15
Post a Followup	You cannot reply to this message because you are not logged in.