Subject	Just coat with non synthetic engine oil that will be used >>
Posted by	ZUL8TR on June 07, 2015 at 4:18 AM
	This message has been viewed 267 times.
In Reply To	Fresh overbore + Wiseco pistons, how to store block? posted by james92se on June 06, 2015 at 01:56 PM
Message	for break in. Then cover with some plastic rap. Is the oil pan on? Might want to put it on, ,if no wrap the whole engine. Not a fan of WD40 it is not an oil. I assume you super cleaned the cylinders with hot water and soap till no residue when wiped with paper towel then oiled them up before piston and rings install? ZUL8TR in Orlando,FL
Follow Ups	Fresh overbore + Wiseco pistons, how to store block? - james92se 13:56:33 06/06/15 I have not done it personally,but I've see a block come out - itsa300zx 14:24:09 06/06/15 My heads were off my short block for a few months - flashstar 16:20:44 06/06/15 Just coat with non synthetic engine oil that will be used >> - ZUL8TR 04:18:08 06/07/15 Re: Just coat with non synthetic engine oil that will be used >> - sky z 08:13:09 06/07/15 The machine shop installed the rings/pistons for me -> - james92se 17:43:50 06/07/15 Ask them how they cleaned the cylinders after the >> - ZUL8TR 02:29:05 06/08/15 Re: Fresh overbore + Wiseco pistons, how to store block? - MaxxAction 09:04:11 06/07/15 I never said it was hard? Just wanted a specific example (n/m) - james92se 17:45:30 06/07/15 ATF (n/m) - -Grimm- 10:18:25 06/08/15
Post a Followup	You cannot reply to this message because you are not logged in.