Subject	Wasn't my FAQ. I just read it in a post somewheres. IMO,
Posted by	Zuberman on June 03, 2015 at 3:13 AM
	This message has been viewed 217 times.
In Reply To	Yeah...it was in your FAQ, right? I agree with you. (n/m) posted by jgbatlantaZ on June 02, 2015 at 01:52 PM
Message	take ZaXxon's advice and get the correct tool for the job and make the necessary clearances/disassembly of parts to attach and use the tool correctly. Bernie has already stated that beating on those things is not good.
Follow Ups	Anybody replaced rear tie rod ball joint using this way? - jgbatlantaZ 21:21:20 05/31/15 I have done it that way - diamond20601 22:11:42 05/31/15 i can't get it to move AT ALL. - jgbatlantaZ 23:39:47 05/31/15 Sometimes when you push or turn the opposite direction - Zuberman 14:25:28 06/01/15 Aha! OK. I will try that! (n/m) - jgbatlantaZ 15:24:05 06/01/15 Rent the actual ball joint press from an auto parts store. - ZaXxon 15:00:24 06/01/15 Yeah, but the press wont fit in there....unless - jgbatlantaZ 15:25:25 06/01/15 I think I read that in a post somewheres: not enough - Zuberman 15:50:56 06/01/15 Yeah...it was in your FAQ, right? I agree with you. (n/m) - jgbatlantaZ 13:52:32 06/02/15 Wasn't my FAQ. I just read it in a post somewheres. IMO, - Zuberman 03:13:01 06/03/15 You can fit a pitman puller to remove it. - The Sixth 10:55:32 06/02/15
Post a Followup	You cannot reply to this message because you are not logged in.