Subject	Are you going to drill holes or sand the pegs off?
Posted by	BoneZ (MD) on June 02, 2015 at 11:28 PM
	This message has been viewed 212 times.
In Reply To	placement of jdm nose panel emblem posted by jlttz32 on June 01, 2015 at 11:21 PM
Message	I have a JDM panel I can take some measurements of tomorrow. -___________________________________________________________-
Follow Ups	placement of jdm nose panel emblem - jlttz32 23:21:54 06/01/15 It's centered equi-laterally from the sides of the - Zuberman 08:25:06 06/02/15 Re: placement of jdm nose panel emblem - njz 13:30:17 06/02/15 Are you going to drill holes or sand the pegs off? - BoneZ (MD) 23:28:29 06/02/15 Re: Are you going to drill holes or sand the pegs off? - jlttz32 23:18:52 06/03/15 Re: "As long as I don't place the "Z" as an "N"".... LOL! - Zuberman 15:51:59 06/04/15 The emblem comes with double sided tape on it. (n/m) - BoneZ (MD) 09:07:59 06/05/15 Then why is he sanding the pegs off of it? (n/m) - Zuberman 16:50:28 06/05/15 The 1990 panel does not have holes for them. (n/m) - BoneZ (MD) 19:29:19 06/05/15 Re: The 1990 panel does not have holes for them. - jlttz32 00:34:55 06/06/15 Right. Mine's a 1990. Are you saying that the emblem has - Zuberman 01:36:12 06/06/15 The emblem is not designed for USDM Zs. - BoneZ (MD) 11:16:38 06/06/15 Re: Right. Mine's a 1990. Are you saying that the emblem has - jlttz32 23:16:58 06/06/15
Post a Followup	You cannot reply to this message because you are not logged in.