Subject	Cut out small section of a box end just enough
Posted by	ttz'in (norcal) on June 02, 2015 at 5:22 AM
	This message has been viewed 219 times.
In Reply To	Any hints for removing this oil line bolt on turbo? posted by ZUL8R on June 01, 2015 at 09:41 PM
Message	to fit over line and length wise allow you to tap with a hammer setting up some vibration allowing penetrant to soak down.
Follow Ups	Any hints for removing this oil line bolt on turbo? - ZUL8R 21:41:24 06/01/15 Flare nut wrench is your best shot (n/m) - OverZealous (CT) 22:27:00 06/01/15 Thanks very much. (n/m) - ZUL8R 22:53:23 06/01/15 Well, did it work? (n/m) - OverZealous (CT) 18:40:27 06/03/15 Cut out small section of a box end just enough - ttz'in (norcal) 05:22:34 06/02/15 IF it's already rounding off and you're going to replace it - Zuberman 08:31:06 06/02/15 Mine was the same - -Grimm- 09:33:35 06/02/15 Re: Any hints for removing this oil line bolt on turbo? - MaxxAction 10:11:15 06/03/15
Post a Followup	You cannot reply to this message because you are not logged in.