Subject	Rent the actual ball joint press from an auto parts store.
Posted by	ZaXxon on June 01, 2015 at 3:00 PM
	This message has been viewed 239 times.
In Reply To	Anybody replaced rear tie rod ball joint using this way? posted by jgbatlantaZ on May 31, 2015 at 09:21 PM
Message	That way you can wrench on the press. I use an impact on it.
Follow Ups	Anybody replaced rear tie rod ball joint using this way? - jgbatlantaZ 21:21:20 05/31/15 I have done it that way - diamond20601 22:11:42 05/31/15 i can't get it to move AT ALL. - jgbatlantaZ 23:39:47 05/31/15 Sometimes when you push or turn the opposite direction - Zuberman 14:25:28 06/01/15 Aha! OK. I will try that! (n/m) - jgbatlantaZ 15:24:05 06/01/15 Rent the actual ball joint press from an auto parts store. - ZaXxon 15:00:24 06/01/15 Yeah, but the press wont fit in there....unless - jgbatlantaZ 15:25:25 06/01/15 I think I read that in a post somewheres: not enough - Zuberman 15:50:56 06/01/15 Yeah...it was in your FAQ, right? I agree with you. (n/m) - jgbatlantaZ 13:52:32 06/02/15 Wasn't my FAQ. I just read it in a post somewheres. IMO, - Zuberman 03:13:01 06/03/15 You can fit a pitman puller to remove it. - The Sixth 10:55:32 06/02/15
Post a Followup	You cannot reply to this message because you are not logged in.