Subject	Does this help? Looks like there is a washer if I am >>>
Posted by	ZUL8TR on May 29, 2015 at 10:25 AM
	This message has been viewed 226 times.
In Reply To	maybe it's not supposed to be there? posted by shiers69 on May 29, 2015 at 10:09 AM
Message	looking at the right part "ball pin"? [ http://300zx-twinturbo.com/cgi-bin/manual.cgi?list=mt&dir=&config=&refresh=&direction=forward&scale=0&cycle=off&slide=7&design=default&total=37 ] ZUL8TR in Orlando,FL
Follow Ups	Transmission woes - Attridge_300ZX 23:17:08 05/28/15 Did you install a washer along with the new pivot ball? - shiers69 09:33:08 05/29/15 yes I installed the washer (n/m) - Attridge_300ZX 09:44:53 05/29/15 maybe it's not supposed to be there? - shiers69 10:09:45 05/29/15 I would think its supposed to be there. Regardless wouldn't - Attridge_300ZX 10:21:21 05/29/15 Does this help? Looks like there is a washer if I am >>> - ZUL8TR 10:25:44 05/29/15 yea it comes with a washer and calls for one. so I installed - Attridge_300ZX 10:47:21 05/29/15 Those are the 'Insert Springs' that go in your 'O.D. - Zuberman 10:38:35 05/29/15 Awesome thanks! Do you know what the O.D. Coupler does? (n/m) - Attridge_300ZX 10:45:48 05/29/15 It's part of the reverse assembly and meshes with the O.D. - Zuberman 11:02:25 05/29/15 Thanks for the info and advise! I was thinking that I'll - Attridge_300ZX 11:11:07 05/29/15
Post a Followup	You cannot reply to this message because you are not logged in.