Subject	Re: Thats a long time
Posted by	EngineerLV on May 27, 2015 at 6:01 PM
	This message has been viewed 251 times.
In Reply To	Thats a long time posted by -Grimm- on May 27, 2015 at 05:22 PM
Message	Ether we have different opinions on hard run or your underestimating your required cool off time is slightly off. I consider a hard run a spirited drive in and out of heavy boost, not just a single pull.
Follow Ups	gt600 / ms manifolds Installation questions - help - Quick_Z 14:44:13 05/26/15 Re: gt600 / ms manifolds Installation questions - help - EngineerLV 16:23:49 05/26/15 Thank you, great response :) Where cld I find turbo blanket? - Quick_Z 16:45:20 05/26/15 Re: Thank you, great response :) Where cld I find turbo blanket? - EngineerLV 17:10:38 05/26/15 Turbo blankets arent equivalent to heat shields - -Grimm- 09:19:34 05/27/15 If you cool down the engine,that shouldn't be an issue,rght? (n/m) - Quick_Z 10:57:21 05/27/15 Re: Turbo blankets arent equivalent to heat shields - EngineerLV 15:33:59 05/27/15 As it is without a turbo blanket - -Grimm- 15:49:38 05/27/15 After a hard run, I would let it idle to cool down 4-5 min. (n/m) - Quick_Z 16:36:39 05/27/15 Thats a long time - -Grimm- 17:22:25 05/27/15 Re: Thats a long time - EngineerLV 18:01:22 05/27/15 No I figure we probably have similar ideas on that - -Grimm- 09:23:20 05/28/15 Re: No I figure we probably have similar ideas on that - EngineerLV 09:58:21 05/28/15 I meant I would cool it down 4-5 min if using blankets. (n/m) - Quick_Z 10:13:37 05/28/15 Re: As it is without a turbo blanket - EngineerLV 17:54:26 05/27/15 So with blankets, say you have a hard street drive, get on - Quick_Z 10:27:15 05/28/15 Re: So with blankets, say you have a hard street drive, get on - EngineerLV 16:43:17 05/28/15 I may just insulate everything else and leave the turbos bar - Quick_Z 17:47:30 05/28/15 Re: I may just insulate everything else and leave the turbos bar - EngineerLV 18:29:23 05/28/15 ZDDP content is critical for... - -Grimm- 09:07:14 05/29/15 I read in a Subaru forum it's very good for Turbo seals - Quick_Z 09:34:58 05/29/15 Re: ZDDP content is critical for... - EngineerLV 20:34:12 05/29/15
Post a Followup	You cannot reply to this message because you are not logged in.