Subject	gt600 / ms manifolds Installation questions - help
Posted by	Quick_Z on May 26, 2015 at 2:44 PM
	This message has been viewed 239 times.
Message	When installing new z1 gt600r bb turbos, can the oem/stock turbo heat shields be installed on those? I don't see that the original heat shield brackets will fit on the gt600 compressor housing, but I'm sure one of the bolts on the back of the compressor housing can be removed to add the oem bracket. However, it seems that the back of the bolt actually goes all the way through the compressor housing so it can be seen on the inside of the compressor discharge piping. Is it safe to remove one of these bolts and re-install, as far as leaks may go, should I observe any specific directions or warning?
Follow Ups	gt600 / ms manifolds Installation questions - help - Quick_Z 14:44:13 05/26/15 Re: gt600 / ms manifolds Installation questions - help - EngineerLV 16:23:49 05/26/15 Thank you, great response :) Where cld I find turbo blanket? - Quick_Z 16:45:20 05/26/15 Re: Thank you, great response :) Where cld I find turbo blanket? - EngineerLV 17:10:38 05/26/15 Turbo blankets arent equivalent to heat shields - -Grimm- 09:19:34 05/27/15 If you cool down the engine,that shouldn't be an issue,rght? (n/m) - Quick_Z 10:57:21 05/27/15 Re: Turbo blankets arent equivalent to heat shields - EngineerLV 15:33:59 05/27/15 As it is without a turbo blanket - -Grimm- 15:49:38 05/27/15 After a hard run, I would let it idle to cool down 4-5 min. (n/m) - Quick_Z 16:36:39 05/27/15 Thats a long time - -Grimm- 17:22:25 05/27/15 Re: Thats a long time - EngineerLV 18:01:22 05/27/15 No I figure we probably have similar ideas on that - -Grimm- 09:23:20 05/28/15 Re: No I figure we probably have similar ideas on that - EngineerLV 09:58:21 05/28/15 I meant I would cool it down 4-5 min if using blankets. (n/m) - Quick_Z 10:13:37 05/28/15 Re: As it is without a turbo blanket - EngineerLV 17:54:26 05/27/15 So with blankets, say you have a hard street drive, get on - Quick_Z 10:27:15 05/28/15 Re: So with blankets, say you have a hard street drive, get on - EngineerLV 16:43:17 05/28/15 I may just insulate everything else and leave the turbos bar - Quick_Z 17:47:30 05/28/15 Re: I may just insulate everything else and leave the turbos bar - EngineerLV 18:29:23 05/28/15 ZDDP content is critical for... - -Grimm- 09:07:14 05/29/15 I read in a Subaru forum it's very good for Turbo seals - Quick_Z 09:34:58 05/29/15 Re: ZDDP content is critical for... - EngineerLV 20:34:12 05/29/15
Post a Followup	You cannot reply to this message because you are not logged in.