Subject	I have had problems getting the Side Brackets to fit
Posted by	Cjw3 on May 24, 2015 at 7:15 PM
	This message has been viewed 242 times.
In Reply To	Having trouble remounting upper intake plenum posted by bfarren240 on May 24, 2015 at 06:30 PM
Message	On the plenums I have done.. I drill the Side Bracket holes bigger, to accept the bolts.. I figure it's the Gasket Buildup thickness difference.. Mount the Center first, because that is where I want the Seal to be.. then drill/fit the Side bracket to keep the Plenum where it is.. Cj
Follow Ups	Having trouble remounting upper intake plenum - bfarren240 18:30:31 05/24/15 I have had problems getting the Side Brackets to fit - Cjw3 19:15:43 05/24/15 lol really? any gasket build up to cause that much - nonstopna 11:39:17 05/27/15 Not 'Gasket Build Up', It's the Built Up Thickness' (n/m) - Cjw3 20:33:53 05/27/15 Fuel rail ground strap to plenum screw is very, - ttz'in (norcal) 14:23:06 05/25/15 Re: Having trouble remounting upper intake plenum - nonstopna 11:43:01 05/27/15
Post a Followup	You cannot reply to this message because you are not logged in.