Subject	Cannot enter Mode II for O2 sensor monitoring FIXED
Posted by	Goldchocobo on May 21, 2015 at 6:38 PM
	This message has been viewed 277 times.
Message	I thought I would update on my problem, as my previous thread is locked. Original issue was I could not enter the O2 sensor monitoring mode. I would get no CEL blinks while running in Mode II. Turns out I had a broken O2 sensor wire on my right hand side, which caused the entire system to go into failsafe mode (thus, no CEL blinks). Embarrassing, but easily repaired. Hopefully this tiny tidbit of information is found useful by someone in the future.
Follow Ups	Cannot enter Mode II for O2 sensor monitoring FIXED - Goldchocobo 18:38:45 05/21/15 Thanks for the follow-up. (n/m) - my91z 21:19:10 05/21/15 Thanks for the info buddy. (n/m) - LivinTheDream 22:50:26 05/21/15 Appreciate follow up. Good find. (n/m) - ttz'in (norcal) 13:58:02 05/23/15
Post a Followup	You cannot reply to this message because you are not logged in.