Subject	Interesting, thanks for the info
Posted by	BlackholeZ on May 19, 2015 at 12:44 PM
	This message has been viewed 226 times.
In Reply To	The pivot point wears a bit. Its very tight clearance posted by ZXoltan on May 19, 2015 at 12:35 PM
Message	I guess I'll just sand a little clearance on mine now. -Dan VTC Solenoid Caps and install instructions. "Capitalization is the difference between helping your Uncle Jack off a horse, and helping your uncle jack off a horse." "'she' also likes to swap since I think I am going to need to give her to woody again." - Dvlhntr "full alphabetic boost mode" - ChristopherTheOne " Purrs like a sexually satisfied black panther." - BigTDogg "Two oil eating, angry, spinning triangles of death." - turtleboy on rotary engines
Follow Ups	Has anyone else fully disassembled door handles for repaint? - PiotrC70 11:15:56 05/19/15 Yup - you need to cut the pin and buy a suitable replacement - black300zx 11:36:40 05/19/15 Interesting... Thank you! So after you took it out, is it - PiotrC70 14:28:56 05/19/15 While on the topic - BlackholeZ 12:05:30 05/19/15 The pivot point wears a bit. Its very tight clearance - ZXoltan 12:35:24 05/19/15 Interesting, thanks for the info - BlackholeZ 12:44:57 05/19/15
Post a Followup	You cannot reply to this message because you are not logged in.