TwinTurbo.NET: Nissan 300ZX forum - Yup - you need to cut the pin and buy a suitable replacement
Subject
Yup - you need to cut the pin and buy a suitable replacement
Posted by
black300zx
on May 19, 2015 at 11:36 AM
This message has been viewed
267
times.
In Reply To
Has anyone else fully disassembled door handles for repaint?
posted by PiotrC70
on May 19, 2015 at 11:15 AM
Message
I cut the pin in the middle, slid each end out in opposite directions, and then reassembled using McMaster-Carr PNs 93772A115 and 94807A026
Follow Ups
Has anyone else fully disassembled door handles for repaint?
-
PiotrC70
11:15:56 05/19/15
Yup - you need to cut the pin and buy a suitable replacement -
black300zx
11:36:40 05/19/15
Interesting... Thank you! So after you took it out, is it
-
PiotrC70
14:28:56 05/19/15
While on the topic
-
BlackholeZ
12:05:30 05/19/15
The pivot point wears a bit. Its very tight clearance
-
ZXoltan
12:35:24 05/19/15
Interesting, thanks for the info
-
BlackholeZ
12:44:57 05/19/15
Post a
Followup
You cannot reply to this message because you are not
logged in
.