Subject	You are correct, courtesy of Z32 Wiki:
Posted by	Tanley on May 18, 2015 at 1:44 PM
	This message has been viewed 412 times.
In Reply To	Connect Rod Nut Torque Spec ~28-33 ft-lbs? posted by OverZealous (CT) on May 16, 2015 at 05:58 PM
Message	EM-60: Connecting rod bearing nut. Old prints listed 43-48 ft-lbs, which is too tight. Correct torque procedure is as follows: Tighten to 10-12 ft-lbs. Turn nuts 60 to 65 degrees clockwise or, if an angle wrench is not available, tighten nuts to 28-33 ft-lbs.
Follow Ups	Connect Rod Nut Torque Spec ~28-33 ft-lbs? - OverZealous (CT) 17:58:35 05/16/15 You are correct, courtesy of Z32 Wiki: - Tanley 13:44:05 05/18/15
Post a Followup	You cannot reply to this message because you are not logged in.