Subject	When in diagnostic mode start the car
Posted by	FrozTTy on May 16, 2015 at 1:53 PM
	This message has been viewed 253 times.
In Reply To	Cannot enter Mode II for O2 sensor monitoring. posted by Goldchocobo on May 13, 2015 at 07:51 PM
Message	Then try to hold it steady at 2000 rpm's. Your CEL should blink somewhat quickly. If it stays lit up for long or not lit for long, you have some sort of issue that requires troubleshooting. Then "switch" to the other side and repeat procedure to monitor the other o2 sensor and see if CEL blinks quickly.
Follow Ups	Cannot enter Mode II for O2 sensor monitoring. - Goldchocobo 19:51:11 05/13/15 No ideas anyone? - Goldchocobo 00:02:27 05/16/15 Re: Cannot enter Mode II for O2 sensor monitoring. - Placuch 11:24:49 05/16/15 I do this, but get no blinking light. - Goldchocobo 13:25:02 05/19/15 When in diagnostic mode start the car - FrozTTy 13:53:52 05/16/15 As I said in the other post, I do this and get no cel blinks (n/m) - Goldchocobo 13:27:16 05/19/15
Post a Followup	You cannot reply to this message because you are not logged in.