Subject	more benefits to a new harness than just connectors
Posted by	LivinTheDream on May 13, 2015 at 11:25 AM
	This message has been viewed 275 times.
In Reply To	You could do the ultimate cheap route. posted by Goldchocobo on May 12, 2015 at 11:03 PM
Message	The wiring actually gets corroded within the shielding and this hinders proper signal transfer. So they say. "torque gets you off the line...& hp gets you over the line." - TTKeeper
Follow Ups	First plenum pull, any suggestions for the harness? - YlwPrlZTT 21:57:51 05/12/15 Re: First plenum pull, any suggestions for the harness? - Bo (Houston) 22:26:20 05/12/15 Cut Out the Old Harness and Install a New One - flashstar 22:50:41 05/12/15 Can it be done with the engine in? (n/m) - YlwPrlZTT 22:55:07 05/12/15 Yes, but many suggest removing transmission - spicyZ 10:54:18 05/13/15 I've done the entire job with only the plenum removed - flashstar 12:31:23 05/13/15 Did you have to pry bar the hole in the firewall - spicyZ 09:37:34 05/14/15 Nope, I just wrapped the connector tightly with electrical - flashstar 12:28:51 05/14/15 You could do the ultimate cheap route. - Goldchocobo 23:03:51 05/12/15 Assuming the junker connectors don't fall apart>> - ZUL8TR 04:08:56 05/13/15 I will definitely try going that route. Thank you. (n/m) - YlwPrlZTT 08:47:54 05/13/15 When doing injectors see link>>>>>>>>>>>>>> - ZUL8TR 09:08:29 05/13/15 Just find the nice ones - Goldchocobo 09:22:54 05/13/15 more benefits to a new harness than just connectors - LivinTheDream 11:25:54 05/13/15 Yup, my detonation sensor wire corroded 1" back - flashstar 13:02:45 05/13/15 What is the benifit of deleating the PTU? (n/m) - ZUL8TR 13:32:29 05/13/15 "sub harness" because less corrosion points (n/m) - LivinTheDream 13:57:06 05/13/15 and it's off!! I feel accomplished :-) - YlwPrlZTT 23:16:33 05/13/15 good job, now get some tape over those intake ports (n/m) - ZUL8TR 04:32:01 05/14/15 Re: First plenum pull, any suggestions for the harness? - Android300zx 04:48:34 05/17/15
Post a Followup	You cannot reply to this message because you are not logged in.