Subject	You could do the ultimate cheap route.
Posted by	Goldchocobo on May 12, 2015 at 11:03 PM
	This message has been viewed 337 times.
In Reply To	First plenum pull, any suggestions for the harness? posted by YlwPrlZTT on May 12, 2015 at 09:57 PM
Message	It's probably the easiest method too. Doing this cost me about 20 bucks. Go to a junker, find any old Nissan (I went for Qx4's, for whatever reason), and cut off all the plastic connectors you are missing. It helps to take pictures of the connectors you need, so you know what to look for. All Nissans have these. Back at your car, DEPIN (don't cut) the old crappy plastic connectors off, clean the connections if necessary with a little wire brush and brake cleaner, and slide on your new2you connectors. Bam. $500 saved.
Follow Ups	First plenum pull, any suggestions for the harness? - YlwPrlZTT 21:57:51 05/12/15 Re: First plenum pull, any suggestions for the harness? - Bo (Houston) 22:26:20 05/12/15 Cut Out the Old Harness and Install a New One - flashstar 22:50:41 05/12/15 Can it be done with the engine in? (n/m) - YlwPrlZTT 22:55:07 05/12/15 Yes, but many suggest removing transmission - spicyZ 10:54:18 05/13/15 I've done the entire job with only the plenum removed - flashstar 12:31:23 05/13/15 Did you have to pry bar the hole in the firewall - spicyZ 09:37:34 05/14/15 Nope, I just wrapped the connector tightly with electrical - flashstar 12:28:51 05/14/15 You could do the ultimate cheap route. - Goldchocobo 23:03:51 05/12/15 Assuming the junker connectors don't fall apart>> - ZUL8TR 04:08:56 05/13/15 I will definitely try going that route. Thank you. (n/m) - YlwPrlZTT 08:47:54 05/13/15 When doing injectors see link>>>>>>>>>>>>>> - ZUL8TR 09:08:29 05/13/15 Just find the nice ones - Goldchocobo 09:22:54 05/13/15 more benefits to a new harness than just connectors - LivinTheDream 11:25:54 05/13/15 Yup, my detonation sensor wire corroded 1" back - flashstar 13:02:45 05/13/15 What is the benifit of deleating the PTU? (n/m) - ZUL8TR 13:32:29 05/13/15 "sub harness" because less corrosion points (n/m) - LivinTheDream 13:57:06 05/13/15 and it's off!! I feel accomplished :-) - YlwPrlZTT 23:16:33 05/13/15 good job, now get some tape over those intake ports (n/m) - ZUL8TR 04:32:01 05/14/15 Re: First plenum pull, any suggestions for the harness? - Android300zx 04:48:34 05/17/15
Post a Followup	You cannot reply to this message because you are not logged in.