Subject	Australian TT core support
Posted by	MegaZ on May 07, 2015 at 7:29 PM
	This message has been viewed 337 times.
Message	A fellow Z32TT owner in Australia asked me to make him a WingZ. His measurements seemed odd so I asked him to measure again. There was a variation and a pic. The core support is not flat, but arched, and it seems to be missing the attachment points for the large nose panel bracket, which I have read is part of the airbag system. Has his core support been altered, or is this standard for Australia? Stage XII 1991 Z32TT
Follow Ups	Australian TT core support - MegaZ 19:29:43 05/07/15 Re: Australian TT core support - MegaZ 20:01:11 05/07/15 its bent. had 3 jdm's nun like that - LivinTheDream 16:24:08 05/09/15 I'd say it bent from being jacked up wrong under the car. - Woody75 (Denver) 12:02:24 05/08/15
Post a Followup	You cannot reply to this message because you are not logged in.