Subject	Just for purposes of future searches. Do you loosen up
Posted by	jzack on May 07, 2015 at 1:29 PM
	This message has been viewed 235 times.
In Reply To	I've never had to remove it. posted by Woody75 (Denver) on May 07, 2015 at 11:04 AM
Message	anything else to make the brake plumbing flex better? In my case, unbolting it gave almost no flex. I would have needed to bend some plumbing to make it go. Given this stuff is well over 20yrs old, that was my concern.
Follow Ups	Please advise- 300 Degree Camber Kit Install >> - stockplayerz(nyc) 13:41:34 05/06/15 Had to remove BMC for mine years ago - spicyZ 16:00:21 05/06/15 I did mine a couple months ago. - Goldchocobo 18:21:26 05/06/15 Reversed the top left bolt so the nut was inside the engine bay. - jzack 20:38:25 05/06/15 Forgot to mention, had no issues using my Dremel cutoff - jzack 20:44:44 05/06/15 I've never had to remove it. - Woody75 (Denver) 11:04:16 05/07/15 Just for purposes of future searches. Do you loosen up - jzack 13:29:14 05/07/15 Nope, just unbolt it from the booster. - Woody75 (Denver) 15:16:01 05/07/15
Post a Followup	You cannot reply to this message because you are not logged in.