Subject	Forgot to mention, had no issues using my Dremel cutoff
Posted by	jzack on May 06, 2015 at 8:44 PM
	This message has been viewed 254 times.
In Reply To	Reversed the top left bolt so the nut was inside the engine bay. posted by jzack on May 06, 2015 at 08:38 PM
Message	wheel to get the spacers cut. For some reason I was able to wiggle the BMC enough to get the oem bolts out. I guess just easier pulling out than inserting.... Again, years ago since I did all this....
Follow Ups	Please advise- 300 Degree Camber Kit Install >> - stockplayerz(nyc) 13:41:34 05/06/15 Had to remove BMC for mine years ago - spicyZ 16:00:21 05/06/15 I did mine a couple months ago. - Goldchocobo 18:21:26 05/06/15 Reversed the top left bolt so the nut was inside the engine bay. - jzack 20:38:25 05/06/15 Forgot to mention, had no issues using my Dremel cutoff - jzack 20:44:44 05/06/15 I've never had to remove it. - Woody75 (Denver) 11:04:16 05/07/15 Just for purposes of future searches. Do you loosen up - jzack 13:29:14 05/07/15 Nope, just unbolt it from the booster. - Woody75 (Denver) 15:16:01 05/07/15
Post a Followup	You cannot reply to this message because you are not logged in.