Subject	Honestly I would strongly consider removing the screen
Posted by	Zuberman on April 30, 2015 at 9:16 AM
	This message has been viewed 235 times.
In Reply To	MAF Screen Replacement posted by Tanley on April 29, 2015 at 06:03 PM
Message	because what if a piece of the screen were sucked back into the engine. Could be very costly. According to many, and not just Z'ers, lack of the screen(s) is not the cause of abnormal operation. Or I would bite the bullet and replace it with a new one or good used one. But hey, that's just me :)
Follow Ups	MAF Screen Replacement - Tanley 18:03:57 04/29/15 Honestly I would strongly consider removing the screen - Zuberman 09:16:49 04/30/15 Also, most use epoxy to re-install; not silicone. (n/m) - Zuberman 09:42:04 04/30/15 For hot wire measuring devices like MAF the screen was>> - ZUL8TR 12:34:06 05/01/15 Not sure if that was meant for Tanley? Even though I - Zuberman 14:06:46 05/01/15 The primary reason I note for the screen is air >>l - ZUL8TR 15:50:11 05/01/15
Post a Followup	You cannot reply to this message because you are not logged in.