Subject	Re: Make the pins on the conectors are clean, like
Posted by	anthony90_z32 on April 22, 2015 at 10:53 PM
	This message has been viewed 233 times.
In Reply To	Make the pins on the conectors are clean, like posted by Red Hawk (CO) on April 22, 2015 at 12:01 PM
Message	The harness look good but the coil pack connector is broken. By broken I mean the black part on top doesn't sit flush. Im not sure if this would be a big problem but I assume it not putting pressure on the wires allowing them to mobe arround
Follow Ups	help, have problems with injector and coil packs - anthony90_z32 22:10:56 04/21/15 Make the pins on the conectors are clean, like - Red Hawk (CO) 12:01:50 04/22/15 Re: Make the pins on the conectors are clean, like - slcZ32 13:38:21 04/22/15 Re: Make the pins on the conectors are clean, like - anthony90_z32 22:53:49 04/22/15 What do you mean by the connector doesn't work? - ttsmokin 13:35:18 04/22/15 Re: What do you mean by the connector doesn't work? - anthony90_z32 22:57:11 04/22/15 Your PTU connectors are probably corroded then. - ttsmokin 17:27:19 04/23/15 Re: Your PTU connectors are probably corroded then. - anthony90_z32 19:51:05 04/23/15 Sounds like the injector or injector connection. - Zuberman 14:06:19 04/22/15 Re: Sounds like the injector or injector connection. - anthony90_z32 22:59:54 04/22/15 Needle files work well - ChristopherTheOne 01:39:59 04/23/15 Re: Re: Sounds like the injector or injector connection. - Zuberman 09:28:58 04/23/15
Post a Followup	You cannot reply to this message because you are not logged in.