Subject	Re: Make the pins on the conectors are clean, like
Posted by	slcZ32 on April 22, 2015 at 1:38 PM
	This message has been viewed 252 times.
In Reply To	Make the pins on the conectors are clean, like posted by Red Hawk (CO) on April 22, 2015 at 12:01 PM
Message	yea, sounds like the evil green monster has visited you. Clean the connectors on the coil pack and the injector terminal also, make sure they are super clean, otherwise when you attempt to do the ohm reading, you'll get no signal. Make sure to also check if you are getting volts to the connectors, and do an ohm test on the coil pack as well. Check your sparkplug.
Follow Ups	help, have problems with injector and coil packs - anthony90_z32 22:10:56 04/21/15 Make the pins on the conectors are clean, like - Red Hawk (CO) 12:01:50 04/22/15 Re: Make the pins on the conectors are clean, like - slcZ32 13:38:21 04/22/15 Re: Make the pins on the conectors are clean, like - anthony90_z32 22:53:49 04/22/15 What do you mean by the connector doesn't work? - ttsmokin 13:35:18 04/22/15 Re: What do you mean by the connector doesn't work? - anthony90_z32 22:57:11 04/22/15 Your PTU connectors are probably corroded then. - ttsmokin 17:27:19 04/23/15 Re: Your PTU connectors are probably corroded then. - anthony90_z32 19:51:05 04/23/15 Sounds like the injector or injector connection. - Zuberman 14:06:19 04/22/15 Re: Sounds like the injector or injector connection. - anthony90_z32 22:59:54 04/22/15 Needle files work well - ChristopherTheOne 01:39:59 04/23/15 Re: Re: Sounds like the injector or injector connection. - Zuberman 09:28:58 04/23/15
Post a Followup	You cannot reply to this message because you are not logged in.