Subject	help, have problems with injector and coil packs
Posted by	anthony90_z32 on April 21, 2015 at 10:10 PM
	This message has been viewed 351 times.
Message	My z has been misfiring off and on for about a week now. Traced it down to cylinder #2. When It was misfiring 2 days ago I ohm checked the injector and got no reading at all but I ohmed it once again today since it wasnt misfiring and i got 12.6 like its supposed to read. The coil pack wire connector also doesn't work when my z Is misfiring. I know that when injectors start to go bad they have similar effects as mine but how can it be linked to my coil pack wire connector?
Follow Ups	help, have problems with injector and coil packs - anthony90_z32 22:10:56 04/21/15 Make the pins on the conectors are clean, like - Red Hawk (CO) 12:01:50 04/22/15 Re: Make the pins on the conectors are clean, like - slcZ32 13:38:21 04/22/15 Re: Make the pins on the conectors are clean, like - anthony90_z32 22:53:49 04/22/15 What do you mean by the connector doesn't work? - ttsmokin 13:35:18 04/22/15 Re: What do you mean by the connector doesn't work? - anthony90_z32 22:57:11 04/22/15 Your PTU connectors are probably corroded then. - ttsmokin 17:27:19 04/23/15 Re: Your PTU connectors are probably corroded then. - anthony90_z32 19:51:05 04/23/15 Sounds like the injector or injector connection. - Zuberman 14:06:19 04/22/15 Re: Sounds like the injector or injector connection. - anthony90_z32 22:59:54 04/22/15 Needle files work well - ChristopherTheOne 01:39:59 04/23/15 Re: Re: Sounds like the injector or injector connection. - Zuberman 09:28:58 04/23/15
Post a Followup	You cannot reply to this message because you are not logged in.