Subject	I was convinced I had a wrist pin going
Posted by	BlackholeZ on April 20, 2015 at 1:01 PM
	This message has been viewed 262 times.
In Reply To	Part 2: Wrist pin or Piston slap? posted by Draker (Eugene, OR) on April 19, 2015 at 10:38 PM
Message	I had a rattle that would only happen as I was transitioning on and off the gas, when the engine was neither pushing or pulling. I was told by many it was a wristpin. When I got the engine apart I had 2 toasted bearings. It's really impossible to tell without pulling the motor. -Dan VTC Solenoid Caps and install instructions. "Capitalization is the difference between helping your Uncle Jack off a horse, and helping your uncle jack off a horse." "'she' also likes to swap since I think I am going to need to give her to woody again." - Dvlhntr "full alphabetic boost mode" - ChristopherTheOne " Purrs like a sexually satisfied black panther." - BigTDogg "Two oil eating, angry, spinning triangles of death." - turtleboy on rotary engines
Follow Ups	Part 2: Wrist pin or Piston slap? - Draker (Eugene, OR) 22:38:32 04/19/15 Is that with the engine at operating temperature? - Tanley 11:51:09 04/20/15 Engine is at temp. - Draker (Eugene, OR) 12:52:32 04/20/15 I was convinced I had a wrist pin going - BlackholeZ 13:01:28 04/20/15 The thing is, it goes a way when the engine is at temp. - Draker (Eugene, OR) 13:52:21 04/20/15 How was your oil pressure? (n/m) - Draker (Eugene, OR) 13:53:02 04/20/15
Post a Followup	You cannot reply to this message because you are not logged in.